|
James N. Rhoten Masonry Contractors, Inc. |
![]() |
The bricks used to build this house were Glen-Gery Lorraine Full Range oversized, hand-made bricks. The arches over the garage doors, with keystones in the center, were constructed using whole bricks. A template was made to support the brick work until the mortar was set. The joints were tooled with a grapevine striking iron. This house features quoin corners, arches over the windows and doors, a slate entry way plus half-moon louvers in the gables. |
|
![]() |
|
|
| Back to Samples | ||
![]() |
These arches were constructed with Cushwa Santa Fe oversized bricks. A half brick was used at the top of the windowsill to create the desired curve. The mortar used was Brick Lok Type N standard mortar. The parabolic arch over the doorway was constructed from whole brick with a keystone. The joints were tooled with a grapevine striking iron. | |
| Back to Samples | ||
![]() |
This wall-to-center-beam
fireplace extends from floor to ceiling. It was built using
Continental Martinsburg Type Antique 30X brick with Black Velvet mortar.
Joints were raked 1/4" from the face of the brick. It features an 8"
raised hearth and a full 8" brick mantle. To the left and right of
the fireplace opening are two storage areas for firewood. The
standard fireplace opening contains a 36" Vestal Damper with rotary
controls. A Sierra Hearth stove was added for greater heat output.
|
|
| Back to Samples | ||
![]() |
Cushwa Rose Red Range
brick was used to construct this floor to ceiling fireplace with a full 8"
brick mantle and 10" raised hearth. The firebox was lined with
Maryland clay firebrick. It has an arch above the regular opening.
It was tooled with a grapevine striking iron. Although this is a
full masonry chimney and fireplace, gas logs have been installed.
|
|
| Back to Samples | ||
![]() |
This house was constructed with Cushwa Santa Fe oversized bricks. The mortar used was Brick Lok Type N standard mortar. The joints were tooled with a grapevine striking iron. | |
| Back to Samples | ||
![]() |
These steps were built
with Cushwa Pastel Rose paving brick. The mortar used was Brick Lok
standard mortar. Each step has a 12" tread and a 6 1/2" riser. The
joints were tooled with a grapevine striking iron.
|
|
| Back to Samples | ||
![]() |
This serpentine walkway was made using Cushwa Pastel Rose paving brick. It has an 8" brick border with running bond in between. Lehigh mortar was used. A slicker striking iron was used to tool the joints. The walkway is supported by 4" compacted gravel underneath a 4" concrete base. | |
| Back to Samples | ||